SubdivideXSI 2004-06-09 - By Guy Rabiller
Back
There is another way in v4:
Press '+' for Subdivision Surface, but set the Subdivision 'Rule' ( in
Geometry Approximation ) to 'Linear'.
--
guy rabiller | 3d technical director @ LaMaison
-- -- Original Message -- --
From: "Dan Yargici" <dan@(protected)>
To: <XSI@(protected)>
Sent: Wednesday, June 09, 2004 2:27 PM
Subject: Re: SubdivideXSI
> Do you have v4? If so, just use the Dice Polygons tool! :)
>
> I've been playing with the knife tool too - very, very, nice indeed :)
>
> DAN
>
> -- -- Original Message -- --
> From: "pablo kirschke" <pablo.kirschke@(protected)>
> To: <XSI@(protected)>
> Sent: Wednesday, June 09, 2004 3:30 PM
> Subject: SubdivideXSI
>
>
> > once again.
> > hi list.
> > there was a beautyful time in softimage 3.9,
> > where it was easy to subdivide your polygon objects,
> > by just tiping in the amount of U & V subdivisions...
> >
> > god helge had once al link to a tool.
> > http://www.mindthink.de/ohm/SubdivideXSI
> > but its dead.
> >
> > any solutions?
> > best pablo
> > ---
> > Unsubscribe? Mail Majordomo@(protected) with the following text in
body:
> > unsubscribe xsi
> >
> ---
> Unsubscribe? Mail Majordomo@(protected) with the following text in body:
> unsubscribe xsi
>
>
---
Unsubscribe? Mail Majordomo@(protected) with the following text in body:
unsubscribe xsi
|
|
