 | | | Subject: Re: lattice problems with NURBS | Subject: Re: lattice problems with NURBS 2003-12-08 - By Dru Abrams
Back
Not my specialty, but just make sure you're selecting both patches when you
bind to the lattice. I could easily see things getting screwy if you only
select border cv's off of 1 patch, but not common border cv's off of two
attached patches...
d
Arielle wrote:
> I'm having a problem with creating a lattice around a certain area of CVs on
a NURBS surface. I have a NURBS head that I'm going to lip sync. The head was
created in pieces and then stitched together using global stitch. When i try to
create a lattice around the CV's for either the upper or lower lip of my model,
the rest of the head gets all contorted. A CV from the lower eye area gets
pulled out through the front of the face, and other grotesque looking
deformities. The only two things in each head piece's history is the global
stitch and the layer it belongs to. And all the pieces are in the same layer. I
dont know why the model's head is getting disfigured when I try to create a
lattice around selected CV's on the lips. Can anyone help me out, and point in
the right direction?
> Thanks
> Arielle
>
> -- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---
> List-help: <mailto:listar@(protected)?Subject=help>
> List-unsubscribe: <http://www.highend3d.com/maya/listserver/>
> List-subscribe: <http://www.highend3d.com/maya/listserver/>
> List-archive: <http://www.highend3d.com/maya/archive/>
--
Dru Abrams
3D Artist
Persistent Visions
http://www.persistentvisions.com
Instructor
Expression Center for New Media
http://www.expression.edu
-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---
List-help: <mailto:listar@(protected)?Subject=help>
List-unsubscribe: <http://www.highend3d.com/maya/listserver/>
List-subscribe: <http://www.highend3d.com/maya/listserver/>
List-archive: <http://www.highend3d.com/maya/archive/>
|
|
|