Boolean after NURBS conversion 2005-05-14 - By mendrak
Back
Nice looking boat. But was there something else supposed to be there
besides the jpg?
hans_k wrote:
> mendrak <mendrak@(protected)> skrev den Sat, 14 May 2005 12:14:53
> -0700:
>
>> Ultimately though I want the boat to be a shell (not
>> just a surface). Adding the width has been driving me crazy.
>
>
> Yea, I also have the experince that it is hard to do any booleans on
> polyhedron
> made from nurbs. Probably because it is still surfaces, not solids.
>
> Have a look at this, it might help you:
> http://www.caligari.com/products/trueSpace/ts5/Courses/NurbsDesign/nd00sample
.jpg
>
> (It is the free intro to a course I made for Caligari 2 years ago)
>
> - Hans
>
> __ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ______
> ****************************************************************************
>
> ********
> This message has been checked for all known viruses by the Cable &
> Wireless
> E-mail Virus Protection service, powered by MessageLabs.
>
> To purchase this service, please contact your Cable & Wireless Account
> Manager.
> ****************************************************************************
>
> ********
>
__ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ______
****************************************************************************
********
This message has been checked for all known viruses by the Cable & Wireless
E-mail Virus Protection service, powered by MessageLabs.
To purchase this service, please contact your Cable & Wireless Account
Manager.
****************************************************************************
********
|
|
