Boolean after NURBS conversion 2005-05-14 - By hans_k
Back
mendrak <mendrak@(protected)> skrev den Sat, 14 May 2005 12:14:53
-0700:
> Ultimately though I want the boat to be a shell (not
> just a surface). Adding the width has been driving me crazy.
Yea, I also have the experince that it is hard to do any booleans on
polyhedron
made from nurbs. Probably because it is still surfaces, not solids.
Have a look at this, it might help you:
http://www.caligari.com/products/trueSpace/ts5/Courses/NurbsDesign/nd00sample
.jpg
(It is the free intro to a course I made for Caligari 2 years ago)
- Hans
__ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ____ ______
****************************************************************************
********
This message has been checked for all known viruses by the Cable & Wireless
E-mail Virus Protection service, powered by MessageLabs.
To purchase this service, please contact your Cable & Wireless Account
Manager.
****************************************************************************
********
|
|
