Problem with sweeping 2005-01-28 - By Omar Campos
Back
Hello everyone,
Just to ask a question (someday I hope to post to
this list to answer rather than just ask :)). It's
something like this: I am trying to make a "curved
pipe" figure. So I draw my cylinder and Sweep it. I
then rotate the new section a little, and sweep again
and again. However, I noticed that if I rotate the
cylinder before sweeping it, when I Sweep it and then
try to rotate the new section, it seems to "snap" in
another direction. I think I remember having used
cylinders and sweeping together before and didn't
experience this. Anyone know why this happens?
Sincerely,
Omar
__ ____ ____ ____ ____ ____ ____ ____ ____ ____ __
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
|
|
