 | | | Curve snapping? | Curve snapping? 2003-12-02 - By jason.brummett@(protected)
Back
*I haven't upgraded to 4.5 or 5 yet so this is for 4.0 only.
I've noticed that at times that snapping and/with axis constraint simply
wont work as it's supposed to? The solution I've found that because Maya is
dependent on downstream upstream connections is that if you double click the
move transform button on the left side of the GUI and reset it to transform
in "World" coordinates your axis constraints and snapping come back as they
should. There is probably a logical reason for this but I don't know Maya
yet well enough to explain why. I guess that as one works sometimes you'll
move into transform local or normal etc. transparently and Maya can't find
the point or curve your looking for in those modes. Just tested this and
you definately can't move a CV of a curve constrained along an world axis
and snap to another CV on the same curve in any mode other than "transform
world." However curve snapping should work in all cases.
Jason Brummett
www.stzgraphics.com
-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---
List-help: <mailto:listar@(protected)?Subject=help>
List-unsubscribe: <http://www.highend3d.com/maya/listserver/>
List-subscribe: <http://www.highend3d.com/maya/listserver/>
List-archive: <http://www.highend3d.com/maya/archive/>
|
|
|