Re: A new plug-in "MultiMorph v1.0 " is available! 2004-03-25 - By steven_mcq
Back
Akira Kurozuka wrote:
> I made a new plug-in "MultiMorph v1.0", that is multi target
morphing modifier.
>
> Visit the URL and check it out.
> http://www.kawachi.zaq.ne.jp/kurozuka/akurodigital/
Akira,
I tried the demo version and am impressed with the implementation.
However, I got mixed results when using it with subdivision
surfaces. Two of the morph targets completely shattered the surface
when the sliders were adjusted to positive or negative values. The
third morph target worked fine, no problems interacting with the
subdivision surface.
In all cases, the original was first subdivided, then duplicated to
create three morph targets. Each morph target was made from a new
master of the copy and remained subdivided while the targets were
distorted.
Is this an issue only with the constraints on the demo version? Is
the full version compatible in all morph targets with a subdivision
surfaces model?
If you can get this work cleanly with subdivision surfaces, it will
be wonderfully useful in animating complex surfaces by moving only a
few vertices.
SMcQ
Special $30 OFF transposer until April 16, 2004.
http://www.eovia.com/offers/yahoo.jsp
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Carrara/
<*> To unsubscribe from this group, send an email to:
Carrara-unsubscribe@(protected)
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|
|
