Question about welding, or whatever... 2004-02-04 - By Andrew Turner
Back
Hi!
Ok.. here's the story -
I've created HALF an object in Spline modeler, then converted to Vertex to
duplicate with symmetry and edit.
Once the model is in Vertex modeler, I'd like to be able (after duplicating
with symmetry) to select points from one of the spline modeler's sections
and Fill Polygon - right off the bat it won't work, probably because the
halves aren't attached - so I need to figure out a way to do this. I've
tried welding the top and bottom points of the section in an attempt to make
it a complete uninterrupted polygon but that didn't work...
I've posted an image for reference at
http://www.turnerdesign.net/carrara
Please have a look - any suggestions greatly appreciated!
Thanks,
Andrew
To unsubscribe send a message to
Carrara-unsubscribe@(protected)
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Carrara/
<*> To unsubscribe from this group, send an email to:
Carrara-unsubscribe@(protected)
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|
|
