Re: "Skeletal " Polyhedra? 2004-01-16 - By steven_mcq
Back
--- In Carrara@(protected), "joe_ashear" <j16@(protected)> wrote:
> kagamiishi,
>
> But if you use a negative value for the
> extrusion, and the hollow side of each stick will end up facing
> inwards, and be somewhat less visible.
In the past I've used this method for turning edges into apparent
beams.
Try taking it two steps further by 1) putting your director's camera
inside the octagon and extruding (intruding?) the faces till they
almost wrap around to make nearly closed beams, then deleting the
original faces; 2) performing a tolerance weld to join the backsides
of the beams.
SMcQ
To unsubscribe send a message to
Carrara-unsubscribe@(protected)
Yahoo! Groups Links
To visit your group on the web, go to:
http://groups.yahoo.com/group/Carrara/
To unsubscribe from this group, send an email to:
Carrara-unsubscribe@(protected)
Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|
|
