Can one scale a group non-uniformly? 2003-12-13 - By Mike Moir
Back
A note ,to scale in one direction , make sure you select the side of 'one'
of the objects in your selected group, not an 'edge' or side of the group of
objects .
Regards
Mike
> Yes , you can scale a group non-uniformly . It doesn't work well in all
> situations,but does work if all your objects share a common hot point. Try
> expanding the group you want to scale , then deselect the entire group ,
now
> reselect everything that is in this group below the group name is
selected.
> Make sure the group name is not selected. Now in the assembly room scale
in
> the direction you want.The other way would be to get the entire model into
> the vm as one object then you could scale in one direction.
> Regards
> Mike
>
>
>
> To unsubscribe send a message to
> Carrara-unsubscribe@(protected)
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>
-- ---- ---- ---- ------ Yahoo! Groups Sponsor -- ---- ---- ---- ---~-->
Buy Ink Cartridges or Refill Kits for your HP, Epson, Canon or Lexmark
Printer at MyInks.com. Free s/h on orders $50 or more to the US & Canada.
http://www.c1tracking.com/l.asp?cid=5511
http://us.click.yahoo.com/mOAaAA/3exGAA/qnsNAA/_iFolB/TM
-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ------~->
To unsubscribe send a message to
Carrara-unsubscribe@(protected)
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
|
|
