Re: Vertex modeler object smoothing 2003-12-06 - By kentcshum
Back
Ah Yes! Thank you, I swear I had seen something like this from the
manual but couldn't remember where it was... I was actually trying
to hunt it from the side Modeling panels.
Thank you again !
Kent
--- In Carrara@(protected), "Naomi Sullivan" <cathlametw@(protected)>
wrote:
> Just select the whole box, and then at the top choose Selection and
then
> down near the bottom of the list that pops open, you'll see "crease
> edges". Select that, and your extruded box will have nice sharp
edges
> and flat sides.
>
> kentcshum wrote on 12/6/2003, 6:39 PM:
>
> > how do I "un-smooth" the
> > surface of the extruded box so that I can render it to show sharp
> > edges?
-- ---- ---- ---- ------ Yahoo! Groups Sponsor -- ---- ---- ---- ---~-->
Buy Ink Cartridges or Refill Kits for your HP, Epson, Canon or Lexmark
Printer at MyInks.com. Free s/h on orders $50 or more to the US & Canada.
http://www.c1tracking.com/l.asp?cid=5511
http://us.click.yahoo.com/mOAaAA/3exGAA/qnsNAA/_iFolB/TM
-- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ---- ------~->
To unsubscribe send a message to
Carrara-unsubscribe@(protected)
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
|
|
