Changing Defaults 2005-05-23 - By kim aldis
Back
Apart from the obvious preset solution or duplicating passes, no, not that
I've found anyway.
Funny, I was just thinking about cascading, overriding renderoption
parameters the other day. When probably at least your output resolution is
going to be the same right through all your passes it makes a lot of sense.
-- --Original Message-- --
From: owner-xsi@(protected) [mailto:owner-xsi@(protected)] On Behalf Of
Eric Lampi
Sent: 23 May 2005 16:09
To: XSI@(protected)
Subject: Changing Defaults
OK this should be an easy one.
I rarely render .pic anymore, opting for .sgi since it's faster to load into
Flame. How do I set the default render format to .sgi? I would also like
to do the same for the resolution and frame rate.
It's a shame that when you make a new pass it doesn't look at the previous
passes settings. I've had several occasions where I am rushing to get out
some new elements and I forget to change one of those settings. Seems to me
that it should be set once and cascade down for every new pass isntead of
using the default. Just my opinion. :)
Eric
Freelance 3-D Animator, F/X Artist, Particle Man
---
Unsubscribe? Mail Majordomo@(protected) with the following text in body:
unsubscribe xsi
---
Unsubscribe? Mail Majordomo@(protected) with the following text in body:
unsubscribe xsi
|
|
