Clitched Mouse Clicked What ? 2004-02-20 - By Kris Krieger
Back
At 03:29 PM 19-02-04, RorrKonn wrote:
>PC Specks
>Celeron Pent 4, 1.7ghz, Hard drive 80 GB, 1.00 GB RAM.
>GeForce 2 MX 400, 64 RAM
>windowsXP
>
>I was worken in TS 6.6SP2
>something, some where, some how got clicked.
>the mouse recently has gotten a glitch at times it has a mind of it's own.
>got to reinstall the drivers,get a new mouse, something
Hi Ravenn,
It might just be that your mouse needs to have the bottom taken off and the
ball and rollers cleaned. They do accumulate bits of dust and oils that
might be in the air, and can get really gunky. So here is something to try
before you go out and buy something new:
There usually is a way to take off the sub-plate (or whatever one would
call it) that holds the ball in place - so, take it off and take out the
ball. Even if it doesn't look crudded-up, first wipe the ball well with
alcohol, rubbing well; do that a couple of times. Then, take a Q-Tip, dip
in alcohol, then press out most of the liquid (you do not want to get drips
into the mouse's electronics), and carefully wipe down the rollers,
rotating them so taht the entire surface is well-cleaned.
Back when I stil used a mouse, I literally had to to this every week (I';m
awfully persnickety about the cursor's movements).
HTH!
- Kris K.
>
>Anyways the scene started acting like there was no 3D Card.
>could see threw the meshes in sold wire frame.
>couldn't run opengl32,Direct 3D HAL in the scene eather.
>So I thought the Glitched mouse turned the 3D Card drivers off.
>But new TS scene and the other 3D Apps have the 3D Card.
>So it act like I just turned the 3D Card off in this one scene.
>
>Anybody have a clue what the Glitched Mouse Clicked ?
>
>RorrKonn
><http://www.Atomic-3 (See http://mic-3.ora-code.com)D.com>http://www.Atomic-3 (See http://mic-3.ora-code.com)D.com
>
>
|
|
