log file question 2005-04-21 - By peterb
Back
Hm
I open it in notepad before relaunching XSI,
and copy and paste into the script editor.
Its plain text
if you want to load the logfile itself in script editor, you could change
the extension to .vbs
> Hi Bernard,
>
> I know that, but after closing XSI and opening the logfile, I only see a
> one character file. If I copy the logfile and open up XSI again, I still
> have the one character file if opened in the scripteditor???
> What I understood is that the logfile is readable ASCII.....
>
> rob
>
> -- --Original Message-- --
> From: owner-xsi@(protected) [mailto:owner-xsi@(protected)] On Behalf
> Of Bernard Lebel
> Sent: Thursday, April 21, 2005 4:07 PM
> To: XSI@(protected)
> Subject: Re: log file question
>
> When you launch XSI, the log file gets overwritten. You have to make a
> copy before relaunching XSI.
>
>
> Cheers
> Bernard
>
>
> On 4/21/05, Rob Wuijster <rob@(protected)> wrote:
> >
> > OK,
> >
> > I've set the preferences to save a log file (real-time commands and
> > messages) while working in XSI. This works without problems, and I can
>
> > see the filesize grow as I build/adjust my scene.
> >
> > I close XSI and open up the logfile to see what's been logged, but the
>
> > only thing I see is a one character file........
> > According to the manual you can copy/paste from the log to the script
> > editor and rerun the commands from the previous session. So I must be
> > overlooking something very basic here.
> >
> > any tips on this are again appreciated,
> >
> > rob wuijster
> > s-5 multimedia
> > holland
> >
> >
>
> ---
> Unsubscribe? Mail Majordomo@(protected) with the following text in
> body:
> unsubscribe xsi
>
> ---
> Unsubscribe? Mail Majordomo@(protected) with the following text in body:
> unsubscribe xsi
>
---
Unsubscribe? Mail Majordomo@(protected) with the following text in body:
unsubscribe xsi
|
|
