Cross Section Surface - Symmetry (feature suggestion) 2003-12-17 - By Leif
Back
Hi
I remember I had a freeware DOS copy of a 3D program.
In it there was a forms editor, very much like the Cross Section Surface editor
, but with polygons instead of NURBS.
However, there was a very functional SYMMETRY option, either across X or Y or
both.
Following the tutorial on page 97-98 of the tS 6 manual, one have to manually
adjust the 4 profile curves to look approximately symmetrical.
How easy this would have been if all curves moved symetrical to the one being
edited !
It is a feature suggestion, yes...
And also symmetry options in editing curves on a single drawpanel..
Thank you
Kind regards, Leif A
|
|
