 | | | 4.2 instability | 4.2 instability 2005-01-14 - By Todd Alan Peleg
Back
ok.. i just did 2 and 3
in 2.. i had no camerras under any models except the scene model.. so
that rules that out.,.
then i made a layout with no viewmanager.... switched passes.... crash..
so.. that ruled that out...
i was able to load the scene .. and build a new pass based on the
default passs..
so.. hopefully when i load that back up.. it will be ok
thanks dave
todd
Todd Alan Peleg wrote:
> thanks dave.. will check it out..
>
> Dave Lajoie wrote:
>
>> Todd
>> I inviting to check the following things...
>>
>> 1) select each partition one by one, sometime, one will crash upon
>> selection, simply delete it using scripting and reconstruct the
>> partition
>> 2) if you pass use a camera in a reference model, it will cause the
>> render option camera to be "blank" upon scene reload, which could also
>> Crash on switch pass or render. So make sure each render option has a
>> proper camera assigned for rendering.
>> 3) create a layout without the viewmanager, and switch to that layout,
>> then switch pass... Does the crash occurs? If so, it might be a graphic
>> problem.
>>
>> I hope this helps.
>> Dave.
>>
>> | -- --Original Message-- --
>> | From: owner-xsi@(protected) | [mailto:owner-xsi@(protected)] On
>> Behalf Of Todd Alan Peleg
>> | Sent: Thursday, January 13, 2005 9:50 PM
>> | To: XSI@(protected)
>> | Subject: 4.2 instability
>> | | Ok.. i am getting pissed off..
>> | | we are doing this job in 4.2 and i am tired of the | instability
>> issues... | i load a scene.... change the pass from the current one
>> to | another one... which has worked int he past...
>> | | and the whole software crashes.... no.. wait.. not just | failed
>> to save sequence...
>> | | dies.. gone
>> | | i have had this happen almost a dozen times..
>> | | | i also have had my share of scenes crashing because a model |
>> saved out from another scene... a clean model.. from 4.2.... | loads
>> in a nother scene.. then crashes and wont save out... | i have to
>> put the objects in a NEW model... in order to get | it to work..
>> | | | this only took a half day of work (with calls to support) to |
>> figure out...
>> | | is it just me or is this build more unstable than any in a while..
>> | | | ridiculously unstable..
>> | | todd
>> | | ---
>> | Unsubscribe? Mail Majordomo@(protected) with the following | text
>> in body:
>> | unsubscribe xsi
>> |
>> ---
>> Unsubscribe? Mail Majordomo@(protected) with the following text in
>> body:
>> unsubscribe xsi
>>
>>
>>
>>
>
> ---
> Unsubscribe? Mail Majordomo@(protected) with the following text in
> body:
> unsubscribe xsi
>
>
---
Unsubscribe? Mail Majordomo@(protected) with the following text in body:
unsubscribe xsi
|
|
|