3dpi question 2003-12-17 - By Christophe Leske
Back
You need to save right after you did your changes. Also, what symbol are
you using when using fileSaveMode?
Christophe Leske
http://www.multimedial.de
mail: info@(protected)
tel. +49-(0)211 230 99 70
.:. f�rstenwall 157 .:.
::: 40215 d�sseldorf :::
> -- --Original Message-- --
> From: dir3d-l-bounces@(protected)
> [mailto:dir3d-l-bounces@(protected)] On Behalf Of
> Carl Lydon
> Sent: Tuesday, December 16, 2003 8:31 PM
> To: dir3d-l@(protected)
> Subject: [Dir3d-l] 3dpi question
>
>
> Is there a way to change a model or texture name in 3dpi? I realize
> that I could change names by cloning objects to another
> castmember, and
> then cloning them back in with a different name, but I was
> hoping that
> there might be an easier way.
>
> I wish filesavemode wasn't so arbitrary as far as what it saves and
> what it doesn't. Model positions and rotations are saved, and new
> textures and shaders are, but transparency is not, deleting
> or adding a
> motion is not, etc.
>
> -Carl
>
> __ ____ ____ ____ ____ ____ ____ ____ ____ ____
> Dir3d-l mailing list
> Dir3d-l@(protected)
> http://nuttybar.drama.uga.edu/mailman/listinfo> /dir3d-l
>
__ ____ ____ ____ ____ ____ ____ ____ ____ ____
Dir3d-l mailing list
Dir3d-l@(protected)
http://nuttybar.drama.uga.edu/mailman/listinfo/dir3d-l
|
|
